I get a troubleshooting with programming the PIC16F877A within EASYPIC5 development
card. According to advices which are described on the Mikroelektronika documents,
I've installed PICFLASH 7.01 and USB18PRG.exe for I work under Basic Vista with its
32 bits O.S. Otherwise, when I build and program a source, I get the following
Windows message: " Cannot communicate with hardware. Please ensure that device is
attached to USB bus and that the drivers are correctly installed - accès refusé."
even if my jumper is on USB or current entry. Help me please!
+33687683386. Thanks.
...my USB18PRG is known by Vista and installed under hard disk's drivers path
and a window notes that usb mikroelektronika device is ready to run.
card. According to advices which are described on the Mikroelektronika documents,
I've installed PICFLASH 7.01 and USB18PRG.exe for I work under Basic Vista with its
32 bits O.S. Otherwise, when I build and program a source, I get the following
Windows message: " Cannot communicate with hardware. Please ensure that device is
attached to USB bus and that the drivers are correctly installed - accès refusé."
even if my jumper is on USB or current entry. Help me please!
+33687683386. Thanks.
...my USB18PRG is known by Vista and installed under hard disk's drivers path
and a window notes that usb mikroelektronika device is ready to run.
Good luck for your website.
Faithfully...
Dom.